Jump to content

Cura 4.8 and macOS Big Sur — unable to show preview

brisance

By brisance
in UltiMaker Cura

 Share

Recommended Posts

brisance

brisance 0

Posted
Posted · Cura 4.8 and macOS Big Sur — unable to show preview

Hi everyone,

 

Previously, under Cura 4.7 and mac OS Catalina, there was no issue slicing and previewing the print. After upgrading to the official released of Cura 4.8 and mac OS Big Sur, however, I can still slice the model, but there is no play back button to preview the print. Any suggestions to fix?

    • Link to post
    Share on other sites
    nallath

    nallath 1,120

    Posted
    Posted · Cura 4.8 and macOS Big Sur — unable to show preview

    The lack of a playback button is caused by Cura reverting to legacy openGL mode. This is either done because a preference forces it back to legacy mode (this is done from within cura, check preferences) or because your drivers tell Cura that opengl 4.1 isn't supported.

     

     

    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...