Tronxy X5SA pro 400

[Marmarossa 0]

Hey All,

 

The current Travel Speed for Tronxy X5SA pro 400 is limited to 141.5mm/s, and whenever I set it above that, it becomes red and unable to slice.

 

I would like to know if it is possible to override that limit and set it to 250mm/s on Cura, instead of changing the G-Code after slicing.

 

Many thanks in advance.

 

Mario 

[nallath 1,124]

As far as I understood, the firmware has a hard limit of 150.