4.8 outputs ufp for ender3 v2 instead of GCODE.

[lscott848 0]

When I save a print file from CURA 4.8 it saves it as ufp file instead of GCODE. I haven't found any setting or pull downs to change it. I'm sure its something I'm missing

[ahoeben 1,849]

When you added your printer to Cura, did you select the Ender 3 from the list, or did you just leave the default Ultimaker S5 profile selected and named it "Ender 3 v2"?

 

A quick way to check: does it say "Ultimaker" on your buildplate?

Edited December 21, 2020 by ahoeben