bridging lines in the preview mode?

[curasurf 5]

In the preview mode, the bridging areas are displayed as Top/Bottom layers.

 

How can I know whether a yellow lines are bridging lines?

 

Thank you!

[Cuq 206]

Switch to PrusaSlicer

[curasurf 5]

1 hour ago, Cuq said:

Switch to PrusaSlicer

 

Thank you! Recentlyy I just switched from Simplify3D to Cura. To get to be confident with all the settings of a new slicer is a painful process.

[kmanstudios 1,120]

36 minutes ago, curasurf said:

Thank you! Recentlyy I just switched from Simplify3D to Cura. To get to be confident with all the settings of a new slicer is a painful process.

I feel for you as it is not just the settings, but the basic philosophical approach on how the programs differ or slight nomenclature differences. Good luck!! 🙂