Raster Angles

[reblacklaf 0]

I have been trying to get the raster angles to work. I use the following settings: [0, 90, 180, 270]. It still prints at the normal 45 degree angle. I started with [0, 90] and kept adding an additional angle trying to get it to work.

 

Randall Black

[GregValiant 1,410]

I usually print the infill at [0,90] so it isn't parallel to the top/bottom.  I've switched the top/bottom around sometimes as well with no problems.

Load a model and use File | Save Project and post the 3mf file here.