ABS printing on ultimaker 2

[richard-a 0]

Hi. I was just wondering if anyone has any tips on printing with abs. I have an ultimaker 2 and I can print with PLA no problem, but when I use ABS it always lifts away from the build plate due to warping and if It does not warp away from the build platform then it seems to split and warp some layers higher up on the print.

Any advice would be great!

 

[aaronalai 2]

There are a lot of suggestions in this thread:

http://umforum.ultimaker.com/index.php?/topic/3955-any-advice-on-how-to-get-abs-to-stick-to-the-glass/