Jump to content

Bonjour , besoin d’aide. Merci


Recommended Posts

Posted · Bonjour , besoin d’aide. Merci

Je suis arrêté sur le panneau welcome to ultimaker Cura et «  get started  », je  clique  mais rien ne change: (  je suis sur Windows 10 , chargeant cura 4.9.1,)

j’avais auparavant installé  cura 15.04.3, arrivé dans « préférences », page blanche , donc impossible de configurer en français .j.ai désinstalle cette version ancienne. quelle galère! Merci de l’aide . 

  • Link to post
    Share on other sites

    Posted · Bonjour , besoin d’aide. Merci


    comme personne ne vient à ton secours, je tente une réponse.

    lorsque j'ai des difficultés d'installation de cura, généralement une opération de nettoyage de l'ancienne version est efficace.

    quand je dit nettoyage , c'est suppression complète de tous les répertoires, nettoyage avec CCleaner de la base de registre....

    après cela l'installation se passe mieux...généralement 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
          • Like
        • 7 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    • Create New...