Jump to content

PLA stops extruding, sometimes after a few layers, sometimes after the prime blob

lxlpeng

By lxlpeng
in UltiMaker 3D printers

 Share

Recommended Posts

lxlpeng

lxlpeng 0

Posted
Posted · PLA stops extruding, sometimes after a few layers, sometimes after the prime blob

Hi there!

 

I am new to this forum and also quite new to printing - until so far, quite exciting! We just got a UMS3 at our work and we have only been printing with PLA and PVA. Mostly it has been going fine, but lately, the PLA sometimes just seems to give up. It happened already a few times that it starts printing, but then after a few layers, somehow it just seems to stop. And then the Bowden Tube also comes out in the back (see img. 1 and 2). I have then also tried to clean the nozzle with the hot-cold pull, and to clean the feeder. Sometimes it works then again, but sometimes not. Today, after this failed print in img 1 and 2, I even swapped the PLA roll, and then it started printing like img 3... The filament seems to be OK in the beginning, because it comes out clean while loading the filament, and the prime blob comes out ok. Does anyone have any suggestions what I could do and what is going wrong??

 

Thanks!!

01.jpg

02.jpg

03.jpg

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • Introducing the UltiMaker Factor 4

        Introducing the UltiMaker Factor 4

        ArunC posted a topic in UltiMaker 3D printers,

        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
        MariMakes

        Picked By

        MariMakes,
      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...