UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Cura Changes Z Height from -1.410 mm to around -5mm, completely messing up my print.
Posted
· Cura Changes Z Height from -1.410 mm to around -5mm, completely messing up my print.
There are a couple of things about your Startup Guide in regards to Marlin firmware. These may be because your "Prusaware" is different.
G28 does not list a "W" flag.
G80 is not a leveling command. Typically it would be G29 or M420.
G1 Y-3 is an odd move.
The purge line appears to be from X0 Y-3 to X60 Y-3 and then continues to X100 Y-3. There is no mention of a Z height so it appears to be at a Z of zero or some offset called by M851.
I think a Prusa forum would be your best bet for support.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
GregValiant 1,364
There are a couple of things about your Startup Guide in regards to Marlin firmware. These may be because your "Prusaware" is different.
G28 does not list a "W" flag.
G80 is not a leveling command. Typically it would be G29 or M420.
G1 Y-3 is an odd move.
The purge line appears to be from X0 Y-3 to X60 Y-3 and then continues to X100 Y-3. There is no mention of a Z height so it appears to be at a Z of zero or some offset called by M851.
I think a Prusa forum would be your best bet for support.
Link to post
Share on other sites