Replacement Paterns for heater of different tools

[Marc_XYZ 0]

Hi there,

 

My first post here, there is some info I cannot find or it does not exist.

 

I know cura can output stantby temperature for all the tools at startup,

 

What I need is the temperature of first layer and printing temperature of each tool available in the start GGcode section of cura.

So I can put the cura variable in my RRF variable.

 

set global.T1_temp={material_print_temperature}(for tool1)

And do the same for all the tools.

 

unfortunately {material_print_temperature} output temp for only the active extruder .
...

 

This is the only info I had found, but no individual temp...

http://files.fieldofview.com/cura/Replacement_Patterns.html

 

Thanks in advance.

Marc

[ahoeben 1,965]

You can do that like this:

set global.T1_temp={material_print_temperature,1}

Instead of a number, you can also specify a variable extruder number, eg:

set support_extruder_temp={material_print_temperature, support_extruder_nr}

 

[Marc_XYZ 0]

Thanks,

 

That's what I was looking for!

 

And is there a list of all cura variables (support_extruder_nr)?? it can be useful.

[ahoeben 1,965]

Any variable from http://files.fieldofview.com/cura/Replacement_Patterns.html can be used, but obviously not all of them will have useful results. In that long list, sarch for "_extruder_nr". It is basically all settings in Cura where you select an extruder, plus the "initial_extruder_nr".