Jump to content

Supports where none is needed


Recommended Posts

Posted · Supports where none is needed


I am getting supports outside an object I am printing. Support towers straight up into open air, stops at about half the height of the object I am printing.

I turned the support setting "Use towers" off, and then 4 out of 6 towers disappeared, but 2 remains.

How come these unnecessary supports pops up, and how do I get rid of them?

Object designed in Fusion 360, printer is a UM S5



  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    • Create New...