-
Our picks
-
UltiMaker Cura 5.8 beta released
ArunC posted a topic in UltiMaker Cura,
Another Cura release has arrived and in this 5.8 beta release, the focus is on improving Z seams, as well as completing support for the full Method series of printers by introducing a profile for the UltiMaker Method.-
-
- 1 reply
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
Picked By
MariMakes, -
-
Recommended Posts
Smithy 1,145
I don't know your printer, but as a beginner I would start with the software which comes with your printer or what the vendor suggests to use. Later you can check if it is possible to use other slicers as well.
Basically you need a printer profile for Cura or you create your own and use custom printer in Cura. Then you can slice and copy the gcode file to a SD card or USB stick, whatever your printer uses.
Link to post
Share on other sites