Jump to content

Nozzle Oozing before leveling and after


RogueWave

Recommended Posts

Posted · Nozzle Oozing before leveling and after

A few seconds before bed leveling operation starts, significant amout of oozing prevents the level operation to be completed. Have to clean off the oozed from the nozzle, then things are fine

 

After bed level has finish, just before the actual print operation starts, print head is moving to fisrt layer to be printed, oozing from the nozzle again.....

 

To summerize, oozing starts just before bed leveling and just before start of actual print operation.... sometime the oozing at bed leveling not enought to prevent abort other times it will and small oozing compared to bed oozing no real issue on print quality so far.

Oozing started recently too many times, not before, have 4.12.1 What's the causes of oozing?

 

Thanks

 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
      • Ultimaker Cura 5.6 stable released
        Cura now supports Method series printers!
         
        A year after the merger of Ultimaker and MakerBotQQ, we have unlocked the ability for users of our Method series printers to slice files using UltiMaker Cura. As of this release, users can find profiles for our Method and Method XL printers, as well as material profiles for ABS-R, ABS-CF, and RapidRinse. Meaning it’s now possible to use either Cura or the existing cloud-slicing software CloudPrint when printing with these printers or materials
        • 48 replies
    ×
    ×
    • Create New...