Jump to content
Ultimaker Community of 3D Printing Experts

Problem with infill


Recommended Posts

Posted · Problem with infill


Can anyone help me to figure out what is causing this strange infill that I get with PETG?  It's suppose to be cubic.  I found that slowing down the travel speed helped, but that doesn't seem to make much sense.

I tried changing the infill speed (both up and down) and didn't see much difference.  The travel speed (100mm/s down to 60mm/s) made a huge difference.




  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    • Create New...