Jump to content

Recommended Posts

Posted · Stepper Calibration

I have a Tronxy XY 3SE and I would like to print a puzzle box. Up to this point my prints have not needed the precision required of a puzzle box. So I am now I have the need to calibrate the stepper motors. I have read I need to first obtain printer settings by sending the printer an M503. Can this be accomplished using Cura 4.12.1?

 

 

  • Link to post
    Share on other sites

    Posted · Stepper Calibration

    You will need to get Printrun/Pronterface in order to see the response from the printer.  You can send a command from Cura but you cannot see the response.

    On most printers the XYZ are really close to exact from the factory.  The Extruder often needs to be calibrated but the other three don't.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.9 stable released!
        Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements.  Check out the rest of this article to find out the details on all of that and more
          • Like
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Heart
          • Thanks
          • Like
        • 4 replies
    ×
    ×
    • Create New...