UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
You will need to get Printrun/Pronterface in order to see the response from the printer. You can send a command from Cura but you cannot see the response.
On most printers the XYZ are really close to exact from the factory. The Extruder often needs to be calibrated but the other three don't.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
GregValiant 1,364
You will need to get Printrun/Pronterface in order to see the response from the printer. You can send a command from Cura but you cannot see the response.
On most printers the XYZ are really close to exact from the factory. The Extruder often needs to be calibrated but the other three don't.
Link to post
Share on other sites