Infill vizible on top surface

[unromeo21 0]

Hi everybody, 

 

so this is a strange issue that I somehow cannot solve. Maybe with some guidance from you, I will manage to fix it. 

As you can see in the image, on that small step-over, the infill is visible and top part of the outer wall is hanging directly on the infill, no support under it.  

 

on that middle layer, it looks like this: 

As you can see, there are only small areas for support on the right side. 

This is for a 2 line outer-wall. If I decrease this to just 1 line, the support is there on the whole perimeter: 

 

I would rather print with 2 line wall thickness, but I don't know which setting to change in order to have the correct support , like for the 1 line wall. 

 

Thanks in advance ! 

 

 

 

[nallath 1,124]

Are you using Cura 4.13? That issue should have been fixed for that version. If that isn't the case, please report it on Github.

[unromeo21 0]

Yes, it the latest 4.13.0 which I just downloaded yesterday. 

[nallath 1,124]

Ah, Could you create a new ticket on https://github.com/Ultimaker/Cura/issues (if you didn't do so already?)