Jump to content
Ultimaker Community of 3D Printing Experts

needing to cold boot after a print job


Recommended Posts

Posted · needing to cold boot after a print job

hello all

after i do a successful print in order to do another print job i have to turn my printer off and then on again every time,if i go and run another print w/out a reboot then the extruder goes thru the motion of printing but the bed stays parked and doesnt move up.,,,this is every time like clockwork.

im running a bibo dual excruder printer

is there a setting im missing somewhere?

 

tia

 

and thx to Gregs help here,im printing like a monkey on steriods,,,thx greg.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT
        I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot! 
          • Thanks
          • Like
        • 4 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...