UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· Cura doesn't recognise Renkforce Printer on Mac
I don't know the Renkforce printers, but I guess you need a driver which was installed on your Air and which is missing now on your new Macbook. The driver is not part of Cura, so take a look at the vendor (Conrad?) if you find something.
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Smithy 1,146
I don't know the Renkforce printers, but I guess you need a driver which was installed on your Air and which is missing now on your new Macbook. The driver is not part of Cura, so take a look at the vendor (Conrad?) if you find something.
Link to post
Share on other sites