Ultimaker Cura Settings for a BiQu BE1 SE Plus Printer

[GrantBaxter 0]

Good day all

 

I have never done 3 D printing before and I have just bought a BiQu B1 SE Plus 3D printer and am struggling to set the printer up effectively and the list of printers in Cura does not show this printer.

 

Is there a printer config file (Profile?) available for the BiQu BE1 SE Plus printer for use in Cura?

 

Thanks and regards

 

Grant Baxter

[GregValiant 1,330]

You need to get with BiQu and find out if they have a Cura printer definition file for your printer.  You could install the smaller B1 in Cura and then make adjustments to the Machine Settings (build plate size) but the B1 does not come with Auto-Leveling.  You would need to find what command the printer uses to call up the auto-level routine and then you need to add it to the StartUp Gcode (also in Machine Settings).

[helakejr 0]

Included on the provided SD card is a cura folder which contains the instructions for creating the BiQu B1 SE Plus printer. Also available on github.