UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Did you go over these instructions? Your model printer is the second one down.
In Cura 4.13 the "Shared Heater" setting is in the Printer Settings plugin. You would need to load "Printer Settings" from the MarketPlace in order to access. You printer does not share heaters and the default is for that setting to be turned off, but you may want to check.
I think everything else is available in the Machine Settings dialog.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
GregValiant 1,342
Did you go over these instructions? Your model printer is the second one down.
In Cura 4.13 the "Shared Heater" setting is in the Printer Settings plugin. You would need to load "Printer Settings" from the MarketPlace in order to access. You printer does not share heaters and the default is for that setting to be turned off, but you may want to check.
I think everything else is available in the Machine Settings dialog.
Link to post
Share on other sites