Jump to content

Ultimaker S5 stops after leveling, cannot abort, plate doesn’t cool down


amjaksic

Recommended Posts

Posted · Ultimaker S5 stops after leveling, cannot abort, plate doesn’t cool down

I’ve been experiencing problems with UMS5. I am printing PC and PVA on Wham Bam flexible build plate coated with PC magigoo adhesive. Currently installed firmware is 6.5.3.

 

Once I send a job (via wifi) it starts normally: The plate heats up, print cores heat up, autoleveling of both cores starts and finishes. At this point the build plate should normally lower to about the middle of the Z and print head should move to center front, then the plate should move up and extrusion would start. However, the print head moves to home and the build plate lowers. The display now shows “Ready to print” and the app on my phone says “Finished After 14min” and nothing is printing or queuing. The buildplate does not cool down and stays at 110C. There are no prints to abort, so the plate stays hot. Queing new prints doesn’t help as they never rech beyond “Preparing” phase. Also, I cannot abort the new job. I cannot leave the printer unattended with a hot build plate overnight so I turned it off forcefully using the turn off button. When I turned it back on again, now the app gets the message “Print failed” and the printer’s display shows the same. I’ve done a full reset and after that the first print successfully finished. But the next one failed again as described above (print head homes and platedoes not cool off until forced shutdown). 
Does anyone know what’s happening here and how to fix it? 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...