good morning Greg
thanks for your answer.
actually I open the GCode. The MAXZ is 20.
;FLAVOR:Marlin
;TIME:1855
;Filament used: 1.34881m
;Layer height: 0.2
;MINX:180
;MINY:180
;MINZ:0.2
;MAXX:222
;MAXY:222
;MAXZ:20
;Generated with Cura_SteamEngine 4.13.1
yesterday evening, I print the cube again. It seems, that the printer first print the bottom, than 4 wrong layers and than he will start with the project. this 4 layers, I can easily remove, but than the cube have no bottom.
Recommended Posts
GregValiant 1,342
Pardon my English.
If you open a Cura Gcode file in a text editor you will see the maximum and minimum numbers for the print. The skirt or brim is included in the X and Y numbers. What is your Maximum Z?
These are lines 5 through 10 from a Cura gcode file:
;MINX:42.368
;MINY:56.906
;MINZ:0.2
;MAXX:189.281
;MAXY:173.404
;MAXZ:25
You can see that my print could not have been 25.8 because the print head never went that high. (As a matter of pride - this one printed at exactly 25.00.)
Link to post
Share on other sites