1 hour ago, ahoeben said:Here is an explanation about what "non manifold" means:
A cross-section can never have an uneven number of walls; Cura needs to be able to figure out what is enclosed between two skins, and a single skin must allways be inside on one side and outside on the other side.
I think you mean for your outer cylinder to have thickness.
Honestly, I have tried all sorts of thicknesses, different vertex merges, I've been sat at this all day and I can't figure it out. The closest I can get is this:
But I need filament to be where I have scribbled in red, and I just cannot figure it out 😞
Recommended Posts
ahoeben 1,981
Here is an explanation about what "non manifold" means:
https://github.com/Ghostkeeper/SettingsGuide/blob/master/resources/articles/troubleshooting/missing_parts.md#non-manifold-meshes
A cross-section can never have an uneven number of walls; Cura needs to be able to figure out what is enclosed between two skins, and a single skin must allways be inside on one side and outside on the other side.
I think you mean for your outer cylinder to have thickness.
Link to post
Share on other sites