Can't Slice with Overhang Issues (Moai 130)

[mbschick 0]

I'm trying to print a '3D Test Model' with overhangs, bridges, etc. to see what fails. I'm trying to use Ultimaker with a Moai 130 and can slice models that either don't have overhang issues or that are supported properly. The issue is that I am unable to slice this test piece as it has overhang issues that I want to induce failure. Any help is appreciated.

 

Cheers

[GregValiant 1,409]

Load the model into Cura and set up to slice it.  Then use the "File | Save Project" command and post the 3mf file here.

[mbschick 0]

Hi Greg,
I was able to receive a registration code for an old Asura build used for the Moai. If I run into issues there I'll post the file. Thank you.