Cura 5.0 - Walls printing order not optimized

[giugni 1]

Hi all,

I am comparing the same object (ofc) and the same settings (theorically) but i have noted some bad differences in cura 5.0

 

here are my walls settings:

 

 

 

 

 

and here is a short video to show you what i mean: https://streamable.com/shgi0s

(on the left cura 5.0 - on the right cura 4.1.2)

 

1) 0:11 sec: cura 5.0 slice 1 inside wall and then 1 outside wall

2) 0:17 sec: cura 5.0 probably randomize the wall start for each single wall instead raomizing at layer change (same at second 0:23)

3) 0:32 sec: cura 5.0 makes 2 circle of infill around the inner peremiter ???

4) 0:41 sec: cura 5.0 makes 2 circle of infill around the outer peremiter ???

5) 1:00 min: cura 4.1.2 as it should work

 

 

Thanks 🙂