Jump to content

UM3X Display and lights wont turn on - Dead

Recommended Posts

Posted · UM3X Display and lights wont turn on - Dead

When left on for a very long print (about 30 hours) I came back to find the print finished but the whole unit wont turn on. The lights inside the print board and the display won't turn on. There is a very faint clicking noise when the power switch is turned on, but nothing else happens. I've replaced the power supply the ultimainboard, and now the display circuit board and OLED screen. Can anyone tell what's wrong, and if they've had a similar issue?


image.thumb.png.f004f1539c7e9643e3b53afeaad8edf4.png    image.thumb.png.9b8c3bdc9eb4a3ad6b60f5740f90c906.png   image.thumb.png.cb3887e5fe432ba57361b129322559bc.png   image.png.b163e511f9a23a86b57e824156841645.pngimage.png.48b3b08704c8e5195f769319bc3d48a4.png

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
        • 58 replies
    • Create New...