Jump to content

Intro

Hillbilly

By Hillbilly
in Coffee corner

 Share

Recommended Posts

Hillbilly

Hillbilly 0

Posted
Posted · Intro

Hello to everyone in the Ultimaker community. My name is Fred .I am known to this community under the Psodonym "Hillbilly". I am honored to be excepted as member of the Ultimaker community. I hope that I will be able to give help and/or advice as much as recieving help and /or advice. I know that there are lot of people in this Forum that much smarter and have more expieriance with 3D printers than I do. And I hope that in time I will become as savvy with 3D printers as you are. Thank You.

    • Link to post
    Share on other sites
    • 2 weeks later...
    • 2 weeks later...
    Hillbilly

    Hillbilly 0

    Posted
    • Author
    Posted · Intro

    Thank you FaithV for the warm Welcome. I haven`t been following the forum very much since I joined because I haven`t had much time lately,but I do plan to learn as much as I can about 3D printing from the many Experts on this super forum. 

     

    Thanks again for the warm Welcome.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Followers 1
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...