Hi,
for your interest, the mentioned spacer tool can be found here:
https://www.youmagine.com/designs/um3-buildplate-distance-tool
Regards
Hi,
for your interest, the mentioned spacer tool can be found here:
https://www.youmagine.com/designs/um3-buildplate-distance-tool
Regards
Recommended Posts
MariMakes 204
Hey @paulsroom,
This really looks like wrong bedleveling to me.
Did you try the manual leveling from the support page:
https://support.ultimaker.com/hc/en-us/articles/360011471740-Build-plate-leveling-on-the-Ultimaker-3
It suggests:
After performing the manual leveling process multiple times, the springs under the build plate may have become too loose. This means that the build plate is too high, which could cause problems during active leveling.
Reset the position of the build plate to the factory position. To do so, use a spacer tool or a ruler. Adjust the three thumb wheels under the build plate until there is a distance of 14 mm between the bottom of the heated bed and the top of the base plate. After this, run through the manual leveling process once more.
I also heard stories about bad springs influencing the bed leveling. Are you getting proper resistance trying to press the buildplate manually or does it give easily?
Can you let us know if this helps? 😇
Link to post
Share on other sites