Balco HE 170703 Thermistor

[berkztr 0]

Have  a Cocoon, Balco 3d printer, have managed to break the Thermistor. When i replace it with the new one do i have to thread it through the black sock wrap or can i attach it to the outside.

Edited September 23, 2022 by berkztr

[GregValiant 1,287]

Welcome.  You will appreciate that this is the UltiMaker forum so specific support for other printers is kind of hit or miss.  In addition I personally have never heard of a Balco before.  It looks like a basic cartesian printer though and I have done this job on my Ender.

If you tape the ends of the two thermistor wires together and leave a smooth end you should have no problem feeding them through the loom.  You could also straighten a coat hanger, push it through the loom from the mainboard end, and then tape the thermistor wires to it and pull them through.

Tie wrapping them to the outside will work, but is "Mickey Mouse Repair" really the what you want?  It isn't much more difficult to do it right.

[berkztr 0]

Thanks Greg, waiting for replacement bits will try your ideas then.

[GregValiant 1,287]

If you haven't removed the old one yet you could tape the new one to it (Head to tail) and when you pull out the old one the new one will pull in.