Bug Wall speed not changing

[BEprints 0]

Hi all I am after some help

 

Using Cura 5.1.1 and trying to print faster but only skirt/brim, initial speeds and top/bottom speeds will change will changer as soon as it gets to a wall it slows down even though all the speeds are set the same.

Am I missing something or is it a bug?

Printer is a ender 3 v2 running Jyers Marlin 2.1 firmware

Edited October 5, 2022 by BEprints

[IgorFomenko 0]

look at:

small feature options

minimum layer time and speed options

[BEprints 0]

Thanks that was it I has to lower the amount of minimum layer time