Cura anycubic calibration profile

[anno15 0]

Hi there,

for calibration I want to print just 1 (red) wall of this cube but I only can see 2 walls in cura with my profile.

It should look like in image 1.png. In image 2.png you can see the slice of the profile I attached. The file extension have to changed to .curaprofile.

Have anybody a Idea which parameter in the profile is wrong?

 

I use Cura 5.2.1

 

MEGA X-PLA-V1.0 calibration cube.curaprofile

Edited November 6, 2022 by anno15

[GregValiant 1,317]

You have "Alternate Extra Wall" turned on.

 

I hope you aren't using that cube to "calibrate" the flow.  If you do then all you will be able to print correctly will be single wall models.