On 12/20/2022 at 11:18 AM, MariMakes said:Hey @Peter_E6,
Welcome to the Ultimaker Community 🎉
Since Cura is open source, printers are contributed by the community. If you would like to see a change you are welcome to contribute it yourself. You can find instructions here: https://github.com/Ultimaker/Cura/wiki/Adding-new-machine-profiles-to-Cura
It looks like the default printspeed is explicitely defined as 80 by default: https://github.com/Ultimaker/Cura/blame/340e03327ec35c5d25f9b02202f996d0a22f7cca/resources/definitions/creality_ender6.def.json#L22
I think it might be related to your proejct,
Do you have a project file for us? It contains the printer and settings we need for troubleshooting.
To save a project file go to File -> Save project.
Hello,
Correct the default printspeed is explicitely defined as 80, but the travel speed is defined as 200 mm/s. That's the setting "Speed->Travel speed". I have modified the Ender 6 printer definition file to default this to 150 and now everything is fine, that is at least until the next Cura update...
Kind regards,
Peter
Recommended Posts
MariMakes 204
Hey @Peter_E6,
Welcome to the Ultimaker Community 🎉
Since Cura is open source, printers are contributed by the community. If you would like to see a change you are welcome to contribute it yourself. You can find instructions here: https://github.com/Ultimaker/Cura/wiki/Adding-new-machine-profiles-to-Cura
It looks like the default printspeed is explicitely defined as 80 by default: https://github.com/Ultimaker/Cura/blame/340e03327ec35c5d25f9b02202f996d0a22f7cca/resources/definitions/creality_ender6.def.json#L22
I think it might be related to your proejct,
Do you have a project file for us? It contains the printer and settings we need for troubleshooting.
To save a project file go to File -> Save project.
Link to post
Share on other sites