Problems importing profiles in Cura 5.2.1

[jsrfo 0]

I am having difficulty importing a Fat Dragon profile into Cura 5.2.1.

I have two different printers that I use. A Sovol SV01, and a Sovol SV06. I was successful in importing the Fat Dragon profile for the SV01, however when I attempt to install this same profile for the SV06, I get an error stating "Quality type 'Super' is not compatible with the current active machine definition 'fdmprinter'.

I have no idea why it imported for the SV01, but not the newer SV06, and I have no idea how to fix this. It seems odd that it imported for the older printer but not the new one.

Assistance would be greatly appreciated. Thank you in advance.

[MariMakes 203]

Hey @jsrfo,

 

Welcome to the Ultimaker Community 🎉

Thanks for your report 👍

 

I fell into a rabbit hole learning about the Fat Dragon Profiles. 
Super interesting. 🤩

 

I can see that the Sovol SV06 printers only have been added to the Cura Main branch early December.
That means that they have not been in a Cura release yet. 

 

I think the reason that you are seeing this error is related to how you added the Sovol SV06 to your Cura version. 

How did you add your Sovol SV06 printer to Cura?

[jsrfo 0]

Not sure what you mean. I added the printer via the Sovol instruction using their instructions to add files to a few different folders within my Cura installation.

I used method B in the attached word document that I zipped.
 

Adding the SV06 to the Original Cura.zip