Hi @MariMakes,
Thank you for your prompt response!
Attached, please find the Project file.
I am now convinced that something is wrong with my settings (although I did not change it from my previous prints, which were OK). I checked for gradual infill (in Infill settings), which showed me that the option was not selected.
Perhaps the solution could be resetting all the settings and starting from zero 🙂
Sincerely,
Simonas
Recommended Posts
MariMakes 204
Hey @simonask,
Welcome to the Ultimaker Community 🎉
The infill shows up "normally" for me.
So I think it might be related to one of your settings.
It looks like it might be related to gradual infill.
Do you have a project file for us? It contains the printer and settings we need for troubleshooting.
To save a project file go to File -> Save project.
Link to post
Share on other sites