Jump to content

Advanced settings for fast but consistent prints for Cr-10 printer using Cura

sage46447
 Share

Recommended Posts

sage46447

sage46447 0

Posted
Posted · Advanced settings for fast but consistent prints for Cr-10 printer using Cura

Hey I recently purchased a Cr-10 printer and am wanting to start printing clone armor using PETG. What settings would you recommend for me to change in advanced settings to make my prints optimized? They do not need much detail but just want to speed up prints that will be least likely to fail.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...