Mais alors pourquoi lorsque qu'il est tranché de coté les trous ne sont pas bouchés?
Si l'objet n'est pas étanche, c'est sans doute parce-que la face générée renvoie une valeur de 0 u niveau de l'épaisseur et donc est ignorée par CURA.
CURA indique qu'il y a des faces posant problème sur ta capture il me semble.
Mais partage le STL de ton sabre LEGO et je te confirmerai...
Edited by darkdvd-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
darkdvd 977
L'objet n'est pas étanche.
Explications :
Link to post
Share on other sites