UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Stoertie 3
Hi all,
I found out the reason by checking the G-Code. There was the following at the biginning of each layer:
;LAYER:14
;WIPE_SCRIPT_BEGIN
G1 F480 Z4.65
G0 F3600 X100 Y55.346 Z4.65
G0 X120 Y55.346
G0 X100 Y55.346
G0 X120 Y55.346
G0 X100 Y55.346
G0 X120 Y55.346
G0 X134.606 Y55.346 Z4.5
G1 F480 Z4.5
;WIPE_SCRIPT_END
M106 S81.4
Than I looked to the experimental settings and found that the wiping between the layers was marked.
Problem is solved.
regards
Michael
Link to post
Share on other sites