UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I think the best thing at this point is grab the gcode and manually rewrite the grid part
Yes! You should use the G92 command very heavily. G92 resets any axis (in this case extruder or E) to any value where you say, "I know you think you have extruded 1.5mm of filament so far this print and you think you are at E position 1.5 but you are wrong - you are actually at this new position. Right now.".
So once you calculate the needed filament for one line, use G92 for two purposes - at the start of each line do G92 E0 and then you can put the extrusion amount in the line so all the extruding gcodes will have the same E value. Simple.
Also after you finish the grid - set the E value to where the printer expected in the original gcode. So if the deleted code ended at position E73.1247 then you can do an G92 E73.1247 at the end of your grid code so the printer extrudes the correct amount going forwards.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,224
Yes! You should use the G92 command very heavily. G92 resets any axis (in this case extruder or E) to any value where you say, "I know you think you have extruded 1.5mm of filament so far this print and you think you are at E position 1.5 but you are wrong - you are actually at this new position. Right now.".
So once you calculate the needed filament for one line, use G92 for two purposes - at the start of each line do G92 E0 and then you can put the extrusion amount in the line so all the extruding gcodes will have the same E value. Simple.
Also after you finish the grid - set the E value to where the printer expected in the original gcode. So if the deleted code ended at position E73.1247 then you can do an G92 E73.1247 at the end of your grid code so the printer extrudes the correct amount going forwards.
Link to post
Share on other sites