Incomplete Raft top layer

[ZeitRapha 0]

Hi,

has anyone else had this problem?

This is the second time this has happened.

(Cura 5.2.1)

Edited March 4, 2023 by ZeitRapha

[Dustin 161]

From the picture it looks like you might have some hardware issues.
There is a lot of under extrusion all over the print not just the raft.
 

[GregValiant 1,364]

Hi @Dustin and @ZeitRapha,

This "incomplete raft" problem has been reported at least a couple of times on Github (#12276 is one and #13696 is another and it's on the Cura backlog at CURA-9349).  I noted in one of the Github reports that moving the model away from the mid-point of the Cura build plate fixed the issue.