Supports

[WilliamSr 1]

hello Everyone, i am very new to 3D printing i have a anycubic Kobra 

my question is and please bare with me as i said above i am new. i was wondering is there anywhere in UltiMaker software where i can insert a custom support i find most programs have them but not always in the needed spot i am currently printing a chess pcs which has a sword that leans out about 15 deg and there is no support for it and a support would be very helpful. 

[Dustin 150]

The following article talks about how to "block" support with Support Blockers.
You can actually follow the steps and reverse its function and have it generate support only where it is located.
https://support.makerbot.com/s/article/1667411336405

[WilliamSr 1]

Thank you very much Dustin this definitely help me out 😊