UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
BugCura (4.12.1) doesn't set bed temperature in gcode (M140) when it's set to 0 degrees, which causes some printers to use their default temperature instead
Posted
· Cura (4.12.1) doesn't set bed temperature in gcode (M140) when it's set to 0 degrees, which causes some printers to use their default temperature instead
Are you sure you are on Cura 4.12.1?
That version is from October 2022.
There have been a lot of improvements made since that release.
We have a number of settings that "turn off" when you set the value to 0.
There are a lot of cases where that's beneficial because "cool" often means room temperature, and that varies depending on your country and the season. I wouldn't be surprised if that's also the case for this setting. It's unfortunate your printer interprets that as 70 degrees, other firmware versions chose to ignore it.
Is setting the value to 1 instead, a better solution in your case?
Or should matching your room temperature be a better solution?
Hope this helps 👍
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
MariMakes 204
Hey @AlteriusOmega,
Are you sure you are on Cura 4.12.1?
That version is from October 2022.
There have been a lot of improvements made since that release.
We have a number of settings that "turn off" when you set the value to 0.
There are a lot of cases where that's beneficial because "cool" often means room temperature, and that varies depending on your country and the season. I wouldn't be surprised if that's also the case for this setting. It's unfortunate your printer interprets that as 70 degrees, other firmware versions chose to ignore it.
Is setting the value to 1 instead, a better solution in your case?
Or should matching your room temperature be a better solution?
Hope this helps 👍
Link to post
Share on other sites