Jump to content

UMS3 Display is not working

kyraryven

By kyraryven
in Firmware

 Share

Recommended Posts

kyraryven

kyraryven 0

Posted
Posted · UMS3 Display is not working

Hello,

I'm looking for ideas on how to maybe fix a display that is not working well.  The UM S3 is a touchscreen interface and is not responding to touch anymore.  A firmware update occurred in Feb and I have been unable to interact with my UM S3 since. I have tried the Micro SD recovery and the display is still not responding.

I have also tried different Brand new HDMI cables from the display to the board and no change. Display sometimes will respond to touch if I hold my finger on it. But it is hit or miss on whether is responds the way I ask it too.

 

Please does anyone have any suggestions.  I have contacted my reseller support and they suggest I replace the display but I am unable to locate any replacement parts for the display.  My printer is out of warranty.  Any suggestions or advise would be greatly appreaciated.

 

    • Link to post
    Share on other sites
    Dustin

    Dustin 129

    Posted
    Posted · UMS3 Display is not working

    Contact the reseller again, even if they don't list the display on their website they can order it for you.
    All official resellers can order OEM parts not listed on their website's.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...