Paul - Could you please expand on this? What should I look for/change in the CURA settings?
Thanks
Paul - Could you please expand on this? What should I look for/change in the CURA settings?
Thanks
If you have a multi-extruder printer then there are 6 Extruder options to pick from.
"Support Interface Extruder" can be fine tuned to "Support Roof Extruder" and "Support Floor Extruder".
Recommended Posts
Paul_Pawelski 0
Neverminded, Someone pointed out that this is already in the settings, I just didn't figure oufomr the name that it is what I wanted. 😔
Link to post
Share on other sites