Cura Advanced Profile Settings- Best Of ?

[almi 0]

Is there a thread where we share all our best Cura Profile Settings or where can I look up These (e.g. There was once a Profile for Thin walled objects like Vase) ?

 

[neoxm3 0]

yeah, i need the same too.... the most, info about retraction,... people says "4.5 and 45 of speed for best", this settings in my machine causes fails in extrusion, grinding i think is sayed, for me works beter 2 and 30.

These class of info is good to share...

 

[Daid 306]

45mm/s is way too much speed, but older buggy firmware needed this. Usually 25mm/s retraction is what you need.

Other then that, I try to supply good defaults in Cura.