Tree hits my project

[Infowire 0]

What are my doing wrong? Everything is level. My tree support hitting my project? pretty much drags the project off the bed.

I did my lowing with this following steps:

0. Heat - Bed and hot end 60/220

1. screws_tilt_calculate > 1 x 1 x 1

2. z - probe > 0.10mm Feeler Gauge

3. Auto level - Auto level

Maybe I have to change my z hop ?

28C/83F my room

what my room temperature should be? 23C - ?

[Dustin 55]

I think a picture and UltiMaker Cura Project file of the issue would provide much more insight to your issue.
Most of your steps have to do with first layer printing.. not the rest of the print.