How to enable/disable fragmentation of top/bottom layer

[madzero100 0]

Hello,

 

How to enable/disable fragmentation of top/bottom layer lines? I would like to have these yellow lines printed as just one continuous line.

 

Thank you.

[GregValiant 1,287]

If there is something above that gap then Cura is pulling the skin back to allow infill to continue up into the part.

"Skin Removal Width" and "Skin Expand Distance" effect the gap.

[ahoeben 1,955]

Always hard to judge an issue from a single screenshot.

 

You could try setting the "Top/Bottom Pattern" to "Concentric" instead of "Lines".

[madzero100 0]

Ok, here is more info, I hope it will shine some light 🙂

 

 

Edited June 18, 2023 by madzero100

[madzero100 0]

Any ideas? 😃

[GregValiant 1,287]

Can't tell without a project file.

Load the model and set Cura up to slice.  Use the "File | Save Project" command and post the 3mf file here.