Cura will not slice larger files

[Vatard 0]

 I'm currently trying to print ANY type of helmet, such as Wolverine, EDO Halo, Clonetrooper, etc. None of them will slice, as it gives me an error. (See image) I was able to slice and print the Deathstroke mask, but it's smaller and would use less material than the other helmets. I've never had this issue other than when I've tried to get into printing helmets. Has anybody else had this issue, and if so, how did you fix it? Thank you!

[GregValiant 1,115]

Many of the masks/helmets I've seen have errors in them.  Those errors need to be addressed BUT removing the errors is not a guarantee that 5.4.0 will slice them.  There have been numerous reports on Github that involve error-free models that 5.4.0 simply will not slice.

 

4.13.1 has (so far) sliced all of them.  Unless the errors in the model are severe (been known to happen) Cura 4.13.1 will often slice them without repair.

 

My ranking of 5.4.0 continues to fall.

Edited August 4 by GregValiant

[Vatard 0]

On 8/4/2023 at 8:11 AM, GregValiant said:

Many of the masks/helmets I've seen have errors in them.  Those errors need to be addressed BUT removing the errors is not a guarantee that 5.4.0 will slice them.  There have been numerous reports on Github that involve error-free models that 5.4.0 simply will not slice.

 

4.13.1 has (so far) sliced all of them.  Unless the errors in the model are severe (been known to happen) Cura 4.13.1 will often slice them without repair.

 

My ranking of 5.4.0 continues to fall.

Thank you! It has worked so far. However, I'm currently trying to slice an ARC Trooper helmet and it's taking forever to slice. But regardless, it's worked! Thank you!

[Dadkitess 18]

On 8/4/2023 at 2:11 PM, GregValiant said:

Many of the masks/helmets I've seen have errors in them.  Those errors need to be addressed BUT removing the errors is not a guarantee that 5.4.0 will slice them.  There have been numerous reports on Github that involve error-free models that 5.4.0 simply will not slice.

 

4.13.1 has (so far) sliced all of them.  Unless the errors in the model are severe (been known to happen) Cura 4.13.1 will often slice them without repair.

 

My ranking of 5.4.0 continues to fall.

Hey Greg,

 

I remember a kind of ranking of available slicers which included some fork / non official version. I can't find it anymore, can you repost it here or in Private Message ? Thanks !