- Solution
Hi,
it's the BB Core, which is only dedicated to PVA.
For Breakaway, use the AA Core, as for any other (non-abrasive) non-PVA material.
Regards
-
1
Hi,
it's the BB Core, which is only dedicated to PVA.
For Breakaway, use the AA Core, as for any other (non-abrasive) non-PVA material.
Regards
On 8/15/2023 at 1:03 PM, Enigma_M4 said:Hi,
it's the BB Core, which is only dedicated to PVA.
For Breakaway, use the AA Core, as for any other (non-abrasive) non-PVA material.
Regards
Thank you for this, I had the AA08 in there and it didn't like that. AA04 is in now and working with the AA08 in the other extruder. It is printing very nicely now!
On 8/15/2023 at 2:14 PM, Dustin said:
Thank you!
Recommended Posts
LePaul 331
Well, I cleared everything out, restarted and this time I had the ability to Enable the extruder.
Something seems wonky there?
When I was able to select it, I get a warning about the profile
However, it's back...so I'll press on.
Link to post
Share on other sites