Problem with the fact that configuring a printer is obligatory to open Cura

[TOGMUHONI 0]

Hello

 

I've installed the last version of Cura (5.4.0) this day.

I have a Wanahoo Duplicator 12/230 Printer wich need the MKSWifiPlugin to be recognize by cura

 

But when I launch cura, it is an obligation to configure the printer.... but my printer is not recognize because Cura need the plugin to recognize it..

 

But as I can't launch cura, I can't install this plugin...... so I can't use Cura

 

Have you a solution to open Cura without configuring a printer ?

 

Thankx in advance

[ahoeben 1,955]

Just add a Custom FFF printer first. You can remove it later.

[TOGMUHONI 0]

Thank you for your quickly answer

In fact, to configure the printer, after trying your solution, I-ve found all this information here :

https://formation.wanhaofrance.com/slides/slide/slicer-trancheur-611

 

Then, I can add the printer which can be see in the liste of the printer in the first run of Cura.

And, after, I can use the plugin to connect the printer

 

Thank you !!

 

Good night !!